Bedlam - Coraline

Bedlam - Coraline   A request from my daughter, inspired by the character Bedlam from Coraline. This creepy mother only wants to take care of you, catching you in her web before devouring you and leaving your soul trapped in the other world forever.    Perfect for Coralie lovers, or as a general decoration for or all year round! NO AMS, printed in parts and assembled, all that is needed is some time and some glue to keep everything together permenently.    AMS PROFILES ARE AVAILABLE   IMPORTANT - IMPORTANT - IMPORTANT   When removing the hands, be slow and steady, try to loosen the arm, wrist and end of the fingers by hand, not with tools, and gently lift the arm, and fingers away from the support material underneath. It should lift away easily enough with care. DO NOT RUSH   Assembley is simple but be patient, rushing and not allowing things to sit properly will lead to small parts falling out.    📌 Recommended printing settings: Material: PLA Layer height: 0.16 mm Infill: 15% - 8% on main body Nozzle: 0.4mm supports where nessesary - I have tried to make it so all have a surface contacting the plate however due to the detail and complexity of the modeling they sometimes require alot of support, so be aware and be carefull during support removal. Use a naked flame gentley and for short intervals to clean surfaces after removal   Assembly – Recommended Method on multipart models Dry fit: Assemble all parts without glue to check alignment and fit. Cleanup: Lightly deburr edges and pegs where nessesary with a file/modeling tool to ensure uniform contact. All parts are tested and fit together. Optional fix: Use glue for permanent assembly.