Thermoformed Christmas Ornament | Harlequin

The Christmas thermoformed series continues — same mold as the Snowflake ornament, so if you printed that one you only need the halves! https://makerworld.com/en/models/3384600-thermoformed-christmas-ornament-snowflake#profileId-3851406 Dress the tree in a classic diamond pattern with this thermoformed harlequin ornament 🎄 Two mesh discs print flat, form over the dome mold, and clip together into a full round ornament — hollow inside, with a white diamond lattice wrapping over the whole ball and a little white dot sitting in every diamond. The printed cap and ring on top finish it off and give you somewhere to run a hook or a ribbon. The open mesh keeps it light enough to hang off a thin branch while the tree lights glow straight through from behind. Green and white is what I printed; the project file ships red and white like the rest of the series, so swap in whatever fits your tree. Perfect for: Tree ornaments in your own color pairing Hiding a small candy or a folded note inside Gift tags on a wrapped present Garland, wreath, and holiday table decor Stocking stuffers and secret santa fillers 🛠️ Printing Notes Prints flat, no supports Mold and push block in PETG, ornament halves and cap in PLA The pin is tiny — print it with the rest so you don't lose it Use even heat so the mesh keeps its shape while forming Same mold as the Snowflake, so keep it around for the next one Light, round, and festive — the harlequin joins the set. Happy printing 🎄