Climbing Ledge Firefighters!

Climbing Ledge Firefighters The Previous Wall Climbing Soldiers ended up being a really big hit ( https://makerworld.com/en/models/3391530-climbing-ledge-specials-ops-soldiers#profileId-3860125 ) so I'm expanding this limited series by request to a set of Climbing Firefighters! Same exact concept, printed in 2 pieces and intended to glue together. Make sure your part are exactly 90 degrees apart while the glue is setting so the model can sit flush against an edge.    Best printed in Matte Pla due to the number of supports.  Intended to go on the edge of a monitor, but works just fine on any flat ledge.    Scaled to fit a standard Computer Monitor, but can easily scale up if needed (though I didn't intend for these to go super large and ketp details to a minimum*).