Chief book reader mosquito
Peso
41g
Tiempo
7h 31m
Precio
Pregunta por WhatsApp por este modelo o uno similar
Te ayudamos a conseguir este diseño o uno parecido, con precio según color y acabado
Las dimensiones dependen del diseño. Confirmamos las medidas exactas por WhatsApp.
Este diseño es de su creador en MakerWorld y se muestra solo como referencia. Tecnoprints no es dueño del modelo ni de su licencia.
Descripción
Chief book reader mosquito This guy loves reading and a little bit of death on the side. Prints came out very clean in .08mm layer height. I had to make his cape extra thick so it stopped failing with tree support. This one is so chonky it could hold up a car (do not test this). There are some very small and fragile parts, especially the necklace bling. Be careful when removing the tree. You can always super glue them back on after if needed. Added better a looking base but you can cut them off and use your own if wanted. It is a single colour PLA print painted, no AMS needed. Boost MeThank you to all those who have boosted!
Tags
Diseñador
DazzD999