BUMBLE HUGGING SOAP BATH & BODY SOAP HOLDER

No AMS print; multi-part print with dowels and glue is needed. There is also an AMS version available. Photos provided show installation—start from the bottom and work upward. Recommend glue on nails and all joining parts for strength. As shown in the photo, nails on one foot can be glued first, and on the other foot, I glue the nails (4 nails) to the base. There are alignment holes/CUT INS on the base for nails. Place the foot down with dowel flush to the base, and once one foot is in place, push up on the dowel while pressing down on the left foot to seat the dowel fully. Once both feet are glued to the base, I place the main body in the feet for proper alignment and fit before the glue on the bottom of the feet dries. Once the glue dries, lift the main body and apply glue to the underside of the legs or dowel on the feet, place the main body onto the feet, and wait to dry. Insert the right hand first with glue, then the left hand, which goes in afterward. Hands should match the photo; make any needed adjustments before the glue dries. The mouth pops in—press it down firmly into place. REFRENCE THE PHOTOS FOR NAIL ORDER ON HANDS !!!! The white part of the eyes pops in, and the black part requires glue as it is a loose fit. As a side note, I used and recommend clear resin glue or similar for nails and eyes. Any questions, reach out directly.  ONLY ONE OF THE TOP HALFS OF THE BASE IS NEED I PROVED A PHOTO FOR REFRENCE, THE CUT HALF MAKES FOR A FLAT SURFACE SO NO SUPPORTS ARE NEEDED , SAVES TIME AND FILAMENT !   ALSO I PRINTED THE BODY AND BASE TOP AND BOTTOM AT 3 WALLS 5 % INFILL GYRIOD THE REST AT 2 WALLS 3 % INFILL GYRIOD    also one thing to position is the large base dowel it is stepped and matched with the base you can drop it in and rotate and will feel it set in slightly    PLEASE READ!!!!!!!!!! PLATE 7 AND 8 IS PLATE 2 JUST SPLIT IN HALF SO U DONT NEED TO WASTE FILAMENT ON SUPPORTS, U CAN PICK EITHER ONE , PRINT ONLY PLATE 2 ! FOR NO SEAM LINE BUT NEED SUPPORTS OR PLATES 7 AND 8 .. NO SUPPORTS