Obelix - Press-Fit Figure, No AMS

OBELIX - a 45-piece press-fit figure. No AMS needed. About 14 cm tall: Obelix standing with his menhir strapped to his back, his striped trousers, his green belt, his braids and his helmet. Every colour is printed as its own piece. It comes off 9 plates, one colour per plate, so any 0.4 mm printer with one spool at a time will do: there is no AMS anywhere in this model.   · 45 pieces on 9 plates, one filament colour per plate, plus a spare eye · Plate 1 YELLOW (8): the buckle and the seven studs · Plate 2 BLACK (7): the two bows, the two eyebrows, the two eyes and a spare eye · Plate 3 WHITE (5): the trousers and the four white waistband pieces · Plate 4 GRAY (2): the menhir and the helmet · Plate 5 GREEN (2): the two belts · Plate 6 BROWN (8): the two shoes, the two shoulder straps and the four menhir straps · Plate 7 SKIN (3): the torso with the head, and the two arms · Plate 8 BLUE (9): the five trouser stripes and the four blue waistband pieces · Plate 9 ORANGE (2): the hair with the braids, and the moustache · Every piece has its own name in the file, in English and Spanish (e.g. "Right Shoe / Zapato derecho"), the same as in the assembly guide · Assembled: 84 x 92 x 138 mm · He stands on his own, no base needed: the figure leans slightly forward to balance the menhir on his back. Set him on a flat surface   · The five blue stripes, in your hand, into their seats on the trousers. · The trousers, straight down onto the tenons of both shoes, with glue. · The two belts, one on each side, and the buckle from the front. · Studs 1 to 6, three in each belt. · The torso, straight down onto the tenon of the trousers. · The eight waistband pieces, white and blue. · The eyes and the eyebrows, from the front. · The two shoulder straps. · The hair onto the head and the two bows onto the braids. · The four straps, in your hand, around the menhir, with glue. · The menhir, onto the back, on its two tenons. · The right arm, sideways, into the shoulder. · Stud 7, then the left arm. · The helmet, glued on top of the head, and the moustache. The full assembly guide (EN + ES, one picture per step) is in Documentation > Assembly Guide   Printed one? Post a photo - and if you like it, a save helps more than anything else.