Taz - Tasmanian Devil Press-Fit Figure, No AMS

TAZ - a 21-piece press-fit figure. No AMS needed. About 11 cm tall and 15 cm wide: Taz with his arms wide open, his mouth wide open with every tooth, his tongue, his whiskers and his eyebrows. Every colour is printed as its own piece. It comes off 5 plates, one colour per plate, so any 0.4 mm printer with one spool at a time will do: there is no AMS anywhere in this model.   WHAT IS IN THE FILE · 21 pieces on 5 plates, one filament colour per plate · Plate 1 BROWN (2): the body (with the arms and legs) and the head · Plate 2 SKIN (3): the muzzle with the belly, and the two inner ears · Plate 3 RED (1): the tongue · Plate 4 WHITE (4): the eyes, the upper teeth and the two lower teeth pieces · Plate 5 BLACK (11): the inside of the mouth, the nose, the eyebrows, the two pupils and the six whiskers · Every piece has its own name in the file, in English and Spanish (e.g. "Right Whisker 1 / Bigote derecho 1"), the same as in the assembly guide · Assembled: 150 x 112 x 114 mm   · The inside of the mouth, onto the body, on its tenon. · The head, onto the tenon of the body. · The eyes into the head, and the two pupils into the eyes, with a drop of glue. · The eyebrows, into their seat, with glue. · The muzzle with the belly, from the front, onto the tenon of the body. · The six whiskers, each side in order 1, 2 and 3, with glue. · The upper teeth, from inside the mouth. · The tongue, onto its tenon. · The two lower teeth pieces, into their seat, with glue. · The nose, onto the tenon of the muzzle. · The two inner ears, into their seat, with glue. The full assembly guide (EN + ES, one picture per step) is in Documentation > Assembly Guide.   Printed one? Post a photo - and if you like it, a save helps more than anything else.