3g Cable Organizer | Lightweight Clip

Just 2 grams to keep your cables tidy Keep your cables neatly coiled with a compact, reusable organizer weighing just 3g. The S-shaped design holds both sides of a coiled cable in two opposing compartments. Inward-facing tabs help retain the cable, narrowing the openings to reduce the chance of loops slipping out while keeping insertion and removal straightforward. Small enough to carry in a tech pouch or backpack, it is a practical accessory for your desk, drawers and everyday travel. Features Only 2g: a lightweight accessory with minimal filament use. Inward grip tabs: help keep cable loops inside the clip. Rounded tips: make insertion and removal easier. Reusable design: organize, release and coil your cables again. One-piece print: no assembly, screws or glue. No supports required: print flat on the build plate. Dimensions 40 × 15 × 10.5 mm Suitable for charging cables, USB cables and other small cords that fit comfortably inside the compartments. Capacity depends on cable thickness and the number of loops. Recommended print settings SettingRecommendationMaterialPLA or PETGNozzle0.4 mmLayer height0.20 mmWall loops4Infill15%Top / bottom layers4SupportsNoBrimNormally unnecessaryScale100%Place the flat S-shaped face on the build plate, with the walls extending upward. The stated 3g weight applies to the provided print profile; material and slicing settings may affect the final weight.   Boost MeJust 2g, a little less cable clutter! If you find this clip useful, a Boost would mean a lot and help support my next practical designs. Thanks for your support!  Share your make and let others know which material and cable you used!