Spinning Snowflake Wand | Print-in-Place, No AMS

Boost MeSpinning Snowflake Wand ❄️ Hold it up and watch the snowflake spin all the way down the spiral. Flip it and do it again – kids (and adults) can't put it down. Printed in one piece – no assembly, no supports, no glue. The snowflake is captured on the twisted stick right on the print bed. Features Print-in-place: the snowflake prints flat on the bed, the stick and handle grow out of it. 3 tiny tabs in the first layer keep the stick stable while printing – twist the snowflake gently to snap them, then slide it up and down a few times. Matching snowy stand included (same plate). Two colors without AMS: add a filament change at 3.0 mm – blades in one color, centre, stick and handle in another. Print profiles: 0.2 mm PLA and 0.2 mm PETG. Print tips Print exactly as oriented in the file, no supports. Brim is already enabled (8 mm) – keep it, the wand is tall (~24 cm) and thin. Bed-slingers (A1): reduce speed to ~50% for the upper part. Clean build plate for good first-layer adhesion. Also check the Santa version of this wand 🎅