Spider-Man - Press-Fit Figure, No AMS

SPIDER-MAN - a 17-piece press-fit figure. No AMS needed. About 12 cm tall: Spider-Man crouching on one knee, one hand on the ground and the other one pointing, with his black spider on the chest and on the back and his white eyes. Every colour is printed as its own piece. It comes off 4 plates, one colour per plate, so any 0.4 mm printer with one spool at a time will do: there is no AMS anywhere in this model.   · 17 pieces on 4 plates, one filament colour per plate · Plate 1 BLUE (5): the legs (one piece, hips included), the two side panels of the torso and the two arms · Plate 2 BLACK (4): the chest and back spiders and the two eye frames · Plate 3 WHITE (2): the two eyes · Plate 4 RED (6): the body, the head, the two gloves and the two boots · Every piece has its own name in the file, in English and Spanish (e.g. "Right Arm / Brazo derecho"), the same as in the assembly guide · Assembled: 111 x 125 x 120 mm · All 4 plates fit a 180 x 180 mm bed (A1 mini) as they are · He rests on three points: the right boot, the tip of the left boot and the right glove. Set him on a flat surface   · The boots onto the legs: the right one goes up from below, the left one along the shin. · The torso, in your hand: both side panels onto the body. · The arms: the right one goes up into the shoulder, the left one into the side panel from the front. · The gloves, each onto its arm. · Clean the chest grooves and fit the spiders: the chest one from the front, the back one from behind. · The whole torso goes down onto the hip tenon. · The head, in your hand: the eye frames and, inside them, the eyes. · The head goes on last, onto the neck, from the front. The full assembly guide (EN + ES, one picture per step) is in Documentation > Assembly Guide.   Printed one? Post a photo - and if you like it, a save helps more than anything else.