Duo MagSafe Vent Mount, Tesla (iPhone Duo, Opened)

Use the whole 7.6" screen of your iPhone Duo for maps, music, or FaceTime audio while you drive. This mount clips into the 2021 Tesla Model 3’s dash vent slot with a snug, wobble-free hook. It holds the phone open at a 25° lean so the screen is easy to read from the driver’s seat. Apple’s braided MagSafe Charger fits in a pocket behind the right half of the phone. The phone snaps on and starts charging right away. The cable runs down the back of the mount and stays out of sight. I designed it to print easily with as little filament as possible. What you need Apple MagSafe Charger, braided version PETG filament (recommended, since dash temperatures get high in summer) Print settings Material: PETG Layer height: 0.2 mm Walls: 3 Infill: 20–25% gyroid Supports: on the build plate only. They’re needed for the overhanging hook finger and the puck pocket ring. Print orientation: as exported in the 3MF Assembly Press the MagSafe puck into its round pocket. It should click in flush. Route the cable through the channel down the back of the mount. Slide the hook into the vent slot until it catches behind the top edge. Open your Duo and set it onto the MagSafe. Notes Fit tested on a 2021 Model 3. Other years may vary, so print the included vent-hook test piece first. It only takes a few minutes. In winter, close or redirect the vent behind the mount. Warm air on the back of the phone can slow charging. Not affiliated with Apple or Tesla.