Nugferatu - UG VR

"This highly intelligent glider will soar across the UGtopian skies whenever a full moon hits! Shrieking at any UG it can find!” - Dinodex, official UG VR Discord.   Nugferatu - Glider 07   The spooky Nugferatu first arrived in Ugtopia at the beginning of October, ready to help the resident UGlies celebrate Halloween.   This model can be shrank down by a bit in the slicer if you want it smaller, but do it at your own risk!   Make sure to have good bed adhesion for a successful print (lots of pieces spread across a bed can be difficult for printers.)   Sand down or take care to remove ALL supports on the joints if they don't articulate properly. Use PETG or ABS for this model, PLA will cause the joints to loosen in a few days and is reportedly prone to cracking. * DON'T USE IT!   Be careful with the tips of the horns, wings, and teeth, especially while assembling!   Nugferatu can also be a bit hard to balance due to its huge head, but you should be able to make it stand in all the poses in the pictures above!