High detail Haunted Halloween Party Pavilion

Ghostly Gala Haunted Mansion Design Concept "Scare you the moment you open the door" — that's the core idea behind this model. I designed a Halloween haunted house themed around a little-ghosts rave party. With high-detail modeling and a clever multi-part structure, the finished print looks stunning yet is extremely easy to print, and it's fully compatible with Bambu Lab LED accessories to max out your Halloween vibe. This is the haunted house you don't want to miss for Halloween 2026! Features Multi-part design: easy assembly, and effortless multi-color printing results. Minimal supports: super easy to print, beginner-friendly. High-detail model: a refined, premium-looking finished piece. Perfectly matches Bambu Lab LED light accessories. Built-in magnet system: place and swap out small accessories freely for maximum play value. Printing Recommendations House walls: I highly recommend matte PLA for the best detail. A dark gray or black marble PLA works great — I printed mine in black wood PLA and the result is stunning, with excellent detail.. Window glass: print in transparent PLA or PETG. In my profile I set it to 2 wall layers; you can add or reduce layers to adjust the glass transparency to your liking. Assembly Guide Thanks to the multi-part design, assembly is very straightforward. Because the model is not symmetrical, use the following features to check the correct orientation while building: The chimney on the roof should be on the right side. The hole marks on the second-floor walls should face the main entrance. Tip: Set a "pause" in your slicer (Pause to insert magnets) to embed the magnets during printing — no gluing needed afterward. Versions Two sizes are provided — Large and Small — suited for the P1S and A1 mini respectively. Both look great, with the large version delivering even finer detail. Lighting Options This haunted house is designed around the Bambu Lab KC020 RGB LED light, but alternative lighting options are also included. Two light module mounts are provided — print whichever suits your needs: KC020 option: 6 RGB lights fit perfectly inside the building, with 1 placed inside the rooftop pumpkin lantern. Point the LED emitter toward the pumpkin's face for the best glow; in the large version, this light can also be placed inside the ghost for an even more fun translucent effect. MH001 option: use a single round MH001 light for higher brightness — but it requires a power cable and does not support color changing. Note: On the small version, the two lighting options are either/or; on the large version, you can use both at the same time. Magnet System The entire model uses magnets to secure small parts in multiple locations. This approach makes it far easier and more flexible to arrange props, and adds a lot of play value. I use 5 mm diameter × 3 mm high magnets, pre-embedded in several places. Pause points are added to the print files — when the printer pauses, simply drop the magnets into the holes and resume printing. House base: 6 magnet holes are embedded inside the base, used to hold the dancing ghosts and the pumpkin at the entrance. Door model: 1 magnet hole is provided to attach the "door-opening ghost." The ghost models also have magnet holes, but these are not pre-embedded. After printing, simply press a bare magnet firmly into the hole until it sits flush with the model surface; use a tool to help if needed. Important: Plan the magnet polarity in advance. I recommend orienting all base-embedded magnets with the same pole facing up, and all prop magnets with the opposite pole — so they attract each other properly. A Playful Crew of Little Ghosts To make the model more fun, I designed several little ghosts in different poses, scattered throughout the build and all held in place by magnets: Entrance ghost: attaches directly to the back of the door; Window ghosts: come in multiple poses and are held by a single bare magnet placed behind the window; Indoor dancing ghosts: snap straight onto the pre-mapped positions inside the base. Note: The ghost models are hollow, printed with thin walls and supports. Please remove the supports carefully to avoid damaging the surface.