Cute Santa Claus Magnetic Swing - Christmas Decor!

Cute Santa Magnetic Swing! I guess Christmas really isn't as far as I would like to pretend it is… so.. kicking off this years Christmas models with this awesome Santa Claus Magnetic swing!  Like the halloween Ghost swing, this uses 10x3mm magnets with a pause layer for insertion allowing for a seamless tree with built-in magnets!      The model is a combination of individual parts as well as a 4-color AMS print for a color version of the Santa. Please note* there is only a single print profile with both the Multicolor and Single Color Santa in the same print, just print the plate you want.   This does require some gluing to get the tree branches and snow attached to the main tree, as  well as to attach the Santa to the swing.    To assemble, start with the main tree brach and glue on the main snow cap, followed by the second largest one at the base of the brach:   Proceed by attaching the two tree branches to the 2 posts on the main snow cap. The Larger brach/snow piece is attached closest to the edge of the branch, while the smaller branch/snow cap is attached in the middle of the branch as shown below:     Finish the model by gluing the Santa onto the bench and inserting the two swing ropes into the hands: