Milo - The Mask Dog Press-Fit Figure, No AMS

MILO - THE MASK DOG - a 31-piece press-fit figure. No AMS needed. About 15 cm tall: Milo, the Jack Russell from The Mask, wearing the mask. Green head with its ears, big white teeth, a red tongue, a black nose, white eyes with black pupils, a white body with a brown patch, leg and tail, a white tail tip and a black collar with 15 grey spikes. Every colour is printed as its own piece. It comes off 6 plates, one colour per plate, so any 0.4 mm printer with one spool at a time will do: there is no AMS anywhere in this model. · The leg and the brown patch: the leg's tenon into the body; the patch onto its rhombus tenon. · The tail: the tip into the tail, then the tail's plug into the body. · The collar, BEFORE the head. · Spikes 01 to 07: each one's plug into its own hole of the collar. · Spikes 08 to 15: glued, a drop of glue on the base, over its hole. · The mouth, head in hand: mouth interior, upper teeth, lower teeth and tongue. · The eyes, the pupils (inside the eyes) and the nose. · The whole head onto the body. The full assembly guide (EN + ES, one picture per step, and a map of the 15 spikes) is in Documentation > Assembly Guide     Printed one? Post a photo - and if you like it, a save helps more than anything else.