Kratos - God of War Press-Fit Figure, No AMS

KRATOS - a 29-piece press-fit figure. No AMS needed. About 16 cm tall, the God of War himself: axe in his right hand, shield on his left arm, the red tattoo over his left eye, pauldron, straps, skirt and belts. Every colour is printed as its own piece: the red tattoos, the eyebrows and the beard, the gold shield wheel and the purple trousers are PLA. The eyes are painted by hand: they are not printed pieces, they are too small to print well. If you like, also paint the scars, the buckles, the runes of the axe and the red strips of the skirt. The guide shows exactly where the eyes go. It comes off 5 plates, one colour per plate, so any 0.4 mm printer with one spool at a time will do: there is no AMS anywhere in this model. The legs: each boot into its trouser leg, then each trouser leg up into the skirt. · The belly, with its red tattoo already in, onto the skirt. · The pauldron, then the front strap. · The chest with the left arm, straight down. · The right arm: arm, bracer and hand. · The left hand and the shield: red disc and gold wheel. · The chest and shoulder tattoos. · The face, head in hand: tattoos and eyebrows. · The beard, glued. · The whole head onto the neck. · The axe blade and disc onto the upper haft. · The axe into the fist: upper haft, then lower haft. · Hand painting: the eyes; if you like, scars, buckles, runes and skirt strips. The full assembly guide (EN + ES, one picture per step) is in Documentation > Assembly Guide.   Printed one? Post a photo - and if you like it, a save helps more than anything else.