iPhone Duo TPU Phone Case - Customisable

iPhone Duo Case A customisable TPU phone case designed to fit the iPhone duo   About This Design I designed this phone case to allow for customisation in Bambu Studio, by importing your own SVG files as modifiers. By using a combination of TPU for AMS and PLA I was able to create a flexible case with a rigid back (for extra protection) and by printing both materials together allows for for intricate design. I modelled an internal structure that weaves the TPU and PLA together, reinforcing the bond.     Key Features Multi Material: A combination of TPU for AMS and PLA Customisable: Using Bambu Studio or similar  Woven Layers: Reinforced TPU PLA bond Living Hinge: Both side of the case a connected by a small living hinge     Assembly Instructions Step 1: Remove the support material from the Speaker and Volume Button holes   Step 2: Flex the build plate to pop off camera bump, the volume buttons are attached, fold them up as shown then insert in to the case buttons first. There is a small lip on the Camera bump that need to go past the camera hole in the case    Step 3: Carefully Insert your phone in the open position and press in at each corner        Customisation   Print Settings & Recommendations To get the best results, I recommend the following settings: Material: Bambu TPU for AMS, PLA Basic Layer Height: 0.2mm for standard, 0.1mm for finer details Infill: 100% Wall Loops: 2 Supports: Use PLA or a support filament for support interface   Ensure that the TPU is fully dried before printing   Feedback I have only been able to test this with my dummy model so far, so there is a possibility the case may be a little tight or loose so your feedback will be very valuable.     Support! If you enjoyed this model or found it useful, please Like and Share a picture of your make! I love seeing what colour combinations you came up with.