Spiderweb Wind-Spinner (Ball Bearing Mod)

Spiderweb Wind-Spinner (Ball Bearing Mod)   The next special ball bearing wind-spinner which fits my windmill collection: The 2-way spinning cobweb windmill with a themed tail-blade and a spider nut. Unique  Wind-Spinner with a Halloween themed Spiderweb Propeller Design Self adjusting to wind direction with the “Tail Blade” Super smooth spinning through the 608 ball bearing Counter-rotating propellers 3 Propeller sizes are provided as  print profiles, each which left & right spinning direction Rods are stack able to your needed height Boost MeTip: Smoth the axle with sandpaper and you can add some grease or oil for smooth horizontal rotating.   Info: The giant H-Version has also an larger sized "tail" and a larger rod   The Axle is designed for 2 propellers (10mm) and 1 distance. Each propeller need one 608 ball bearing The protective caps are optional CLAMP for Windmills Assembly: Push the 608 ball bearing completely in both propellers The cap is optional! Carefully glue the protective washer to the edge. Be careful not to glue the inner part of the ball bearing.Glue the shaft to the axleInsert the forst propeller to the axle and add the distance ringInsert the second propeller and check if both spin smoothly Use the spider nut on topInsert the tailPrepare the stackable rod with the spikeCongratulations 🎉  Thanks to all followers and don't forget the virtual handshake 👍 ….Happy Printing😉   Commercial license you can get here on Makerworld (Profile on Desktop) or on Patreon: https://www.patreon.com/BamBamDesign/