Christmas KITcard Church – Print-in-One

🎄 Christmas KITcard Church 🎄 Fully printed in one single sheet. All parts are connected with thin break-off bridges. you dont need AMS, only one color switch . Just use small flush cutters to snip out the pieces and assemble the mini church in a few minutes. No glue. No supports. No complicated steps. Perfect as a small Christmas decoration or a simple DIY gift. I made a few changes compared to the kit-card house. I hope assembly will be easier. The tolerances are looser so everything fits together nicely. tested with more colors of PLA and PETG all versions printed well . let bed cool properly to not damage bridges :)       🎄 Assembly 🎄: Cut each part from the card using flush cutters. Clean small nubs if needed. Snap all parts together following the obvious shape/slot layout. Done — enjoy your Christmas mini church! 🎄     Print Settings Material: PLA Layer Height: 0.2 mm Supports: No Nozzle: 0.4 mm                                                                                                                                                                                                                                      color change is in 3mm in 16 layer Please use only 0.2 mm layer height. The model is designed for this height.   If you enjoy this model, feel free to leave a Like, Boost, or Follow. Thank you! 🎄✨ If there are some problems with snapping, please let me know. Boost Mefor all boost i will be very grateful