Sturdy Wall Hook

A small, sturdy wall hook for jackets, bags, keys, headphones, tools or cables. The triangular brace under the arm carries the load down into the wall plate, and the raised lip at the front keeps things from sliding off.   FEATURES: • Size: 55 mm high, 30 mm deep, 15 mm wide • 20 mm opening between wall plate and lip • 5 mm wall thickness throughout • Two countersunk holes for 3.5 mm screws, so the screw heads sit flush • Access hole in the brace, so a screwdriver reaches the lower screw • Rounded edges all around   PRINT SETTINGS: • Orientation: lay the hook on its side, so the L-profile is flat on the bed. This puts the layer lines along the arm and makes it much stronger. • Supports: Tree for holes • Layer height: 0.2 mm • Walls: 4 • Infill: 25 % - Gyroid • Material: PLA works for light loads. Use PETG for heavier loads or in warm or damp rooms.   MOUNTING: You need two 3.5 mm countersunk screws, plus wall plugs that suit your wall. 1. Mark and drill the two holes, 33 mm apart. 2. Fasten the top screw first. 3. Fasten the lower screw through the access hole in the brace.   Leave a comment or post a make if you print it. Feedback is welcome.