Autumn Apple Tea Light Lantern

Bring a cozy touch of autumn into your home with the Autumn Apple Tea Light Lantern, a charming apple-shaped decoration designed to cast a warm and inviting glow.   This lantern was designed to work with LED tea lights with a diameter of up to 40mm and heights between 17-27mm (without flame). The maximum height with flame is ~58mm. It's fully printable without AMS and only needs a small support to help with bridging.   Disclaimer: This design can only be used with LED tea lights. Do not use real candles!     Print Settings My profile is ready to print, you don't need to make changes if you use them.   If you want to slice it yourself, make sure to print the apple parts with 0.16mm layer height because this is required by the self supported regions. Also it helps to ensure good thread quality. Consider adding a manual support to the center of the first bridge of the top part for better bridge quality.     Assembly Assembly only takes a minute and required no tools or parts. The use of glue can be necessary in some cases.   First, press the stem into the apple top until it clicks into place. If force is required, make sure to support the apple top from the inside with your finger. Now insert the leaf. Use a drop of glue if required. Snap the threaded connector piece into the base. Insert your LED tea light and secure it with the holder. Now you can simply screw the base into the apple top. The branch of the holder is simply pressed into the base. If required, add a drop of glue.     Like this design? Check out my Mini Lantern Collection! https://makerworld.com/en/collections/5446140