Santa Cam - Claus Circuit TV

🎅 Santa Cam – Claus Circuit TV Santa is watching! 🎄 Add a little North Pole surveillance to your Christmas decorations or Elf on the Shelf adventures with this miniature Santa Cam. Featuring a festive Santa hat, Claus Circuit TV branding and a green mounting base, it's a fun little prop to keep the Christmas magic alive. 🖨️ Printing Instructions IMPORTANT: All 3 build plates are required to make ONE complete Santa Cam. The model is split across three plates to reduce unnecessary filament changes and waste. Plate 1: Main camera body and rear cover Plate 2: Santa hat and decorative components Plate 3: Green mounting base The supplied Bambu Studio project includes the component arrangement and colour assignments. 🔧 Assembly Print all three plates. Remove any supports and clean up the parts. Test-fit the components before assembly. Apply a small amount of super glue (cyanoacrylate) to the mating surfaces. Assemble and allow the glue to cure fully. Glue is recommended to make the completed camera a solid, permanent display piece. 🐨 About Dodgey Dropbear Designed, prototyped and personally test-printed in Australia. Questionable ideas. Properly tested prints. If you enjoy the model, please consider leaving a rating, sharing a photo of your finished print or giving it a Boost! Happy printing! 🎄