Floating Penguin Bath & Sensory Play Set

Commercial license available through Patreon   Disclaimer: ❤️ These were designed as fun, temporary sensory toys for supervised water play! I personally print mine in PETG, allow them to dry thoroughly after use, and discard them when we're done enjoying them. Since 3D prints are not guaranteed to be watertight, moisture can become trapped inside and lead to mold growth. Always inspect before use, discard if water becomes trapped or mold is suspected, and use at your own discretion. The beauty of 3D printing is that you can always make another set! 🥰   Make water play extra fun with this adorable Floating Penguin Bath & Sensory Play Set! 🐧❄️ This set includes a mama penguin, 3 baby penguins, and a floating iceberg slide. Mama has an open belly area where all three babies can ride along while she floats. The babies can also be removed for play, float on their own, and take turns going down the iceberg slide! Included: Mama penguin 3 floating baby penguins Floating iceberg with slide Mama, all three babies, and the iceberg are designed to float, making this set fun for sensory bins, water tables, bath time, and other supervised water play. 💙 Please note: The iceberg print profile is single color. The blue shown on the slide in the video was created by manually stopping the print and changing filament. It is not a two-color print profile. Water Play Note: These are 3D printed in PLA and are not sealed or watertight toys. Water can enter between layer lines or into the print. Allow pieces to drain and dry thoroughly after water play. They should not be left sitting or stored in water. For the intended floating results, I recommend using the provided print profiles/settings rather than significantly changing the walls or infill.