Throttle + Brake Lever Fidget

Peso
44g
Tiempo
1h 34m
Precio
Pregunta por WhatsApp por este modelo o uno similar
Te ayudamos a conseguir este diseño o uno parecido, con precio según color y acabado
Las dimensiones dependen del diseño. Confirmamos las medidas exactas por WhatsApp.
Este diseño es de su creador en MakerWorld y se muestra solo como referencia. Tecnoprints no es dueño del modelo ni de su licencia.
Descripción
Motorcycle Throttle & Brake Fidget — Twist, Squeeze, Snap Back The throttle grip was only half the gesture. This is the other half. 🏍️ Right hand on the bar: roll the throttle open, feel the spring load up, then grab the brake lever and feel it bite — and both snap back when you let go. The whole choreography your right hand does a hundred times on a ride, now sitting next to your keyboard. 🤚⚡ Roll it open during a status call. Two-finger the brake while the build runs. It’s the full handlebar in your palm, and from across the office it just looks like you’re thinking hard. 😎 Everything here was engineered around the feel: ⚙️ The throttle builds progressive resistance on a printed spring and returns to idle on its own, with a defined stop — same as the standalone version ⚙️ The brake lever has its own printed return spring: squeeze it and it loads, release it and it snaps back to rest. No mush, no dead travel ⚙️ Lever shaped for a two-finger pull, the way you actually brake ⚙️ Knurled grip that bites into your palm, rotation angle matched to the real thing ✅ Print-in-place, in two parts. Each part comes off the plate already working — no supports, no screws, no glue, no hardware of any kind ✅ Assembly is one push. The two parts snap together and stay together. Ten seconds, bare hands ✅ Recommended in PLA for the crispest spring action on both mechanisms 🔧 First use — read this. Straight off the plate the moving parts sit slightly bonded: normal for print-in-place. Hold the body firmly and give the throttle a little pull and one deliberate twist, then work the brake lever through its travel a couple of times, to break them free. Firm and controlled, not a yank. After that they run free forever. Let both parts cool completely before that first twist — the springs can take a set if you load them while still warm. Want it smaller or bigger? A keychain-size version and a full 1:1 real-scale grip are both on the table. Tell me in the comments which one you’d actually use and I’ll design it. 💬 Prefer something more pocketable, throttle only? The original single-piece version is here: 👉 More automotive controls in the series — handbrake, engine piston: 👉
Tags
Diseñador
Bdg Lab 3D