Captain America, NO AMS

a 45-piece press-fit figure. No AMS, no glue, no paint. About 18 cm tall, standing on his own boots, with the shield on his left arm. Every colour is its own solid piece: the stripes, the stars, the helmet A and wings, the eyes and the belt are PLA, not paint. It comes off 6 plates, one colour per plate, so any 0.4 mm printer with one spool at a time will do: there is no AMS anywhere in this model. · The boots onto the legs. · The waist dowel and the red waist band. · The two belt halves and the buckle (before the stripes). · The 10 white stripes, each one into its own seat. · The torso onto the band, then the chest star. · The arm dowels and the forearms. · The gloves. · The shield on the left arm: 5 pieces on one single dowel. · The head. · The eyes: the white, then the iris. · The nape band and the chin strap. · The helmet. · The helmet's A and wings. The full assembly guide (EN + ES, one picture per step) is in Documentation > Assembly Guide · Press-fit, no glue: pins and the 4 dowels have 0.08 mm clearance per side, the colour plugs 0.10 mm. · Dry-fit each piece half way before pushing it home; push straight, along the arrow of each step. · The eyes and the irises are tiny: tweezers help. Printed one? Post a photo - and if you like it, a save helps more than anything else.