Karambit Knife Trainer/Fidget Voronoi Pattern

This is my first 3D printed model I have made. I started making a balisong, but because I was learning blender it was maybe a bit to complicated and I switched to a karambit. Not a perfect CS2 karambit, but it's really good to flip around. Some light sanding might be required so there's no sharp edges sharp bits on the blade finger grooves etc.    For the second plate uncheck remove small overhangs. Also, for the brim you may want to paint it on yourself. I've been having adhesion problems with smaller parts so I just left it as auto. I'm still trying to nail down the orientation and print profile. As I'm pretty new to 3D printing also. Any help/advice with it would be appreciated. The pints should just press fit in. They're about ~.2mm tolerances. They do hold the blade together, but my advice is to add some glue also to make sure they're extra secure. I have a plain version also, but because I have terrible naming schemes I need to figure out which one is which out of like 15 files and then re-export. I will upload that once I export it again and print to make sure it's actually the right one. I changed scaling, pin size, pin locations a few times so it's a bit troublesome. All my prints are using Wondershop PLA Silk or Matte and Bambuu labs Basic (black)   I can also do hexagon, circle, grid/square pattern, custom image also. I had claude make a pattern cutting tool to save me the process of all the booleans unison and cutting.