Finger Flick & Snap Propeller

🚀🌀 Finger Flick & Snap Propeller 🌀🚀 Sometimes you don’t need a launcher, motor, or batteries… just your fingers! 😄☝️ This little flying toy is powered by pure finger-flick power and can fly up to 5 meters away and around 3 meters high with a good, strong snap! 💨✨     Fly Video: 🌀 Quick & Easy to Print The complete set contains 3 different propellers and prints in only around 10 minutes! ⏱️ No supports, no complicated assembly — just press the shaft into the propeller and you're ready for takeoff. ✈️   🔧 different Shaft Sizes Included Depending on your printer and filament, small differences in the printed dimensions can occur. That's why I've included 6 different shaft sizes. Simply try them out and find the one that gives you the best fit with your printer and filament. 👍   Easy Assembly Guide: Assembly Video:   🎨 Single & Dual-Color Profiles Print profiles for both single-color and dual-color versions are included, so you can keep it simple or give your propellers some extra style. 🌈   ⚠️ Pro tip: Start with a gentle flick until you get a feel for the launch, then gradually increase the power. With a little practice, you'll be sending these tiny propellers flying surprisingly far! 😎   Perfect for a quick little desk toy, a fun challenge with friends, or simply seeing how far you can launch your latest print! 🎯       🔧 Behind the Scenes 🌀 Getting this little flyer right took quite a bit of trial and error! 😄 I tested 3-, 4-, 5- and 6-blade propellers in many different shapes and designs, constantly tweaking the geometry, weight and blade profiles. In the end, the winner was surprisingly simple: a lightweight 3-blade propeller with an aggressive wing profile. 🚀 It produced the best combination of speed, lift and flight distance — and was also incredibly fun to launch! Sometimes the best design is the one that survives the most failed experiments. 😉