Climbing Ledge Ninjas!

Climbing Ledge Ninjas   Here is a fun one I've had in the backlog for quite some time and finally got around to making! Some Climbing Ledge Ninjas! Printed in 2 pieces and intended to blue together (though most filaments should result in a decent press fit - Just Be Careful attaching the models together, due to the small size the cylinder can be easy to break*!)    Best printed in Matte Pla due to the number of supports. Intended to go on the edge of a monitor, but works just fine on any flat ledge. Ideally you need to have a flat vertical surface for the hanging ninjas feet to rest against. The top ninja is printed with a modified/heavier infill to bring the center of gravity of the model back over the ledge. In most instances it should work out just fine, but please note that you may need to use a little piece of adhesive in certain situations if you want them to stay put*    Scaled to fit a standard Computer Monitor, but can easily scale up if needed (though I didn't intend for these to go super large and ketp details to a minimum*).