Scx30 Tacoma Flat Bed 2 versions

Here is my next mod for the Axial scx30 Tacoma I have designed this flat bed to give your truck a mean off road look and give it more rear wheel clearance. The V1 flat bed has a headache bar and details like slats in the bed, faux tool boxes on the corners, faux gas cap and fill neck, and I even added a receiver for the license plate hitch the lights are printed clear PLA ans uses the existing light/mount for the old bed. The V2 has the same as above but I also added a tool box and fire extinguisher and a wrench that was “left” on the bed haha!!!    For mounting the bed it uses the existing holes that go into the cab of the truck, mine fit snug so I didnt use the screws but you could try to use the screws but we all know the limits of 3d printing you might need a small drill bit to clean the hole on the cab mounts, Or you can simply uses double side tape to mount it to the cab. The bed also uses the same mount where the stock light “tab” went into, I printed this part in clear PLA and then super glued it on to the flat bed. The clear PLA make it so the red light still shines through from the existing light but if you don't have clear you can print it in black and use a red paint marker.   If you have any questions, comments or suggestions please reach out! Enjoy and have fun!!!