Wavy Picture Frame Magnet - Instax Mini

✨ Parametric Wavy Picture Frame Magnet Transform your fridge, magnetic boards, or workspace into a chic gallery with the Wavy Picture Frame Magnet! Blending the playful, retro curvy silhouette of squiggly Nordic decor with smart functional engineering, this model turns your favorite instant photos into vibrant, tactile design pieces. Engineered primarily around standard Fujifilm Instax Mini (and 54 × 86 mm wallet prints), this parametric creator gives you effortless dual-color contrast, hidden rear corner retention, and flush magnet pockets for a sleek, zero-gap display on any metallic surface.   🚀 Quick-Start Print Profile for Instax Mini Need a super fast print? At under 20g of filament and ~45 minutes per frame, you can batch-print a whole gallery in an afternoon! Jump straight into the included print profiles, featuring color combos tested and tuned to match the cover showcase: Print these profiles directly or open the file in the MakerLab Customizer to adapt the perimeter, wave count, or window aperture to any custom photo format you need!   🛠️ Customizer Guide (How to tweak it in MakerLab) Click the Customize button to configure your tailored frame: 🖼️ Picture Size & Window Lipspicture_width & picture_height: Set your photo card size (default: 55 × 86 mm for standard Instax Mini). window_side_gap: Border overlap holding each side of the photo. window_top_gap & window_bottom_gap: Independent vertical lips, specifically tuned to preserve the classic Polaroid/Instax white chin (16 mm bottom vs 8 mm top). window_corner_radius: Soft rounding for the front window corners. 🌊 Wavy Wall & Outer Profileframe_outer_width & frame_outer_length: Total outer bounds of the frame. wave_length: Spacing between peaks; waves adjust automatically to distribute cleanly along all sides. amplitude: Depth and boldness of the exterior wiggle. border_thickness: Overall wall width. edge_rounding_radius: Micro-beveled top lip to soften the front surface under overhead lighting. 🧲 Magnet Configuration & Heightsmagnet_diameter & magnet_depth: Tuned for common disc magnets (defaults to 6 mm diameter × 2 mm depth). magnet_tolerance: Extra clearance (default: +0.2 mm) for press-fit. base_height & total_height: Controls the base plate thickness (3 mm) and the raised accent border (6 mm). 🎨 Color & Resolution Previewbase_preview_color & wall_preview_color: Select instant preview palettes directly inside MakerLab. render_resolution: Keeps rendering fast during adjustment, then ramps up smoothness for export. 💡 Print & Assembly Suggestions Hardware Needed: 4× Round Neodymium Magnets. They press straight into the 4 rear corner recesses—no glue needed if tuned well, though a single drop ensures a permanent lock. Smart Slide-In Corner Tabs: The back incorporates tiny 0.3 mm corner clips: simply flex your photo slightly and tuck the corners under the tabs. It stays flat, secure, and completely removable without adhesive. Two-Tone Color Swap:With AMS: Set the base and wall parts to two different spools. Without AMS: Add a single pause or filament swap at the transition from base floor to raised wavy wall to get that dual-color look. Supports are implemented with support enforcer to ensure a good finish. Settings: 0.16–0.20 mm layer height, 3 walls, 15% Gyroid infill.  📸 Show Off Your Makes! Decorating your fridge, studio pegboard, or locker? Snap a picture of your setup and share your color combinations and favorite prints in the comments below! 🙌✨