Flashforge Creator 5 & Creator 5 Pro Wiper Mod

Flashforge Creator 5 & Creator 5 Pro Wiper Mod A simple press-fit wiper mod for the Flashforge Creator 5 and Creator 5 Pro. Print the part, remove its built-in support, attach the wiper, and press it into place. Wiper to purchase: https://a.co/d/0dwIgnVS Print Print the model in its supplied orientation at a 0.2 mm layer height. The built-in support has a 0.2 mm gap, allowing it to support the print without physically connecting to the part. Remove the support Snap the support off along the break line. If it is difficult to start, carefully slip a thin, flat edge into the gap to help release it. Clear away any loose bits. Install Remove the printer’s old wiper. Apply the purchased wiper to the end of the printed part. Align the part with the original mounting location and press it in until fully seated. Check that the part is secure and the wiper is positioned correctly before running a print.