Seat Belt Alarm Stopper

Stops the annoying seat belt alarm/chime when using a booster seat, pet harness, cargo, or aftermarket seat without triggering the buckle sensor. This is a male buckle tongue insert — it plugs directly into the seat belt buckle receiver to simulate a fastened belt.   Print settings: • Layer height: 0.16mm • Infill: 15% • Supports: Yes • Material: PETG (recommended for durability — avoid PLA if it'll sit in a hot car)   • Orientation: For best strength and surface finish, print oriented upright/lifted with supports rather than flat on the bed. Fits most standard buckle receivers — check dimensions before printing if your vehicle uses a non-standard connector. Tested on: [Toyota LC300]   ⚠️ For off-road/cargo/pet use only. Always wear your seat belt while driving.