Thermoformed Coffin | Halloween Candy Holder

This one closes out the Halloween thermoform series — the skull, pumpkin, ghost and bat are all up in my profile! https://makerworld.com/en/models/3328757-thermoformed-skull-halloween-candy-holder Bring a little graveyard atmosphere to your desk with this thermoformed coffin container ⚰️ The shell prints flat and forms over the mold into a proper coffin silhouette that splits into two halves. A small pin joins them at the side so the lid swings open, and the cross pressed into the front keeps it readable from across the room. Inside there's room for candy, small gifts, notes, or trinkets. The mesh structure keeps the print lightweight while letting whatever you tuck inside show through — wrapped candy behind the mesh looks especially good, and the cap detail at the top finishes it off. Shown here in purple over white and in black over white, but it works in whatever palette your spooky season needs — all black, orange and black, or a glow filament for the full graveyard effect. Perfect for: Halloween candy and treats Party favors and trick-or-treat handouts Spooky desk or shelf decor Small gifts, notes, and trinkets 🛠️ Printing Notes Prints flat, no supports The push block is included on the plate Heat the printed shell (heat gun or hot water) and press it over the mold Works great in PLA Take your time on the pointed corners — rushing the heat there can thin the mesh Lightweight, spooky, and simple to print — the last box in the Halloween set, and probably the most fitting one ⚰️