Magnetic Ghost Swing- Halloween Printer Accessory!

Magnetic Halloween Ghost Swing! On the Fridge, on the Printer, on your Office Cube wall, anywhere you have a metal surface can now be an awesome place to hand your Ghost Swing!  No AMS required, all parts printed separately. The tree branch has 2 variants, the first is split into two pieces and requires glue for assembly, however, this offers a fully captured (and slightly stronger) swing capture. The down side is needing a little glue and pre-determining which way you want the ghost to swing.  Not worried about the ghost falling off every once in a while? Then just print a one-piece branch on Plate 4 instead, it has hooks to allow for haning of the swing instead!    Assembly Assembly is fairly straightforward, I recommed using a drop of glue on the parts you put together just to keep them from falling apart overtime.  Place the Ghost on the Swing Base making sure to align the holes in the arms.        Next, install the 2 upper swing linkeages making sure the ring openings are facing you as shown here:   If using the split tree branch, place the 10x3mm magnets into one section and glue in the alignment pegs:   Next, hang the swing in the direction you want it to swing on one half othe tree branch:   Apply some glue and close the assembly with the second half of the tree branch, and you're all done!    If using the single-piece tree branch from plate #4 please note there is a PAUSE layer to allow for insertion of the 10x3mm magnets. Please ensure the magnets are not thicker than 10.08mm or you will risk crashing the print head* This tree branch allows for simple hooking of the swing without pre-determining swing direction: