Halloween Cosplay Pikachu scary mask

Turn heads at Halloween, cosplay conventions, or horror events with this Scary Low-Poly Pikachu Mask! Featuring sharp fangs, menacing dark eye outlines, and a stylish low-poly aesthetic, this wearable piece is optimized for easy 3D printing and quick assembly. Key Features Wearable Design: Features dedicated side loops on the left and right to secure an elastic strap or ribbon. Easy Screw-On Ears: Printed in 3 main parts (main mask body + 2 ears). The ears connect seamlessly via built-in threaded screw joints—no glue required for assembly! Please be aware that ears match to the head, just be patient and clean the threads and screw it with some power. AMS & Single-Color Ready: Fully separated plates allow you to print in multi-color with an AMS setup or as clean single-color parts to paint by hand. Plate Layout Overview Plate 1: Multi-Color Mask Main Body (Yellow, Black, Red, White) Plate 2: Multi-Color Ears (Yellow & Black with threaded connectors) Plate 3: Single-Color Mask Main Body (Ideal for single-extruder printers or custom painting) Plate 4: Single-Color Ears (Ideal for single-extruder printers or custom painting) Assembly Instructions Gently remove tree supports from the inside of the mask and the threaded sockets. Clean the threads on the mask, as tree supports may dirt it a litttle bit. Screw the left and right ears directly into the corresponding threaded mounts on top of the mask. Screw it in and out if it would go hard Thread an elastic strap (approx. 15–20mm width) through the side slots, adjust for comfort, and tie or stitch in place. (Optional) Add small foam pads on the interior for custom face cushioning.