Ultimate Lever Multi Click Fidget (Print in Place)

This lever multi click fidget turns one smooth flip into a whole row of clicks instead of just one. The mechanism works by dragging a small bump on the lever handle across a row of flexible plastic strips, bending each one just enough before it snaps back into place with a crisp click, so lining up the strips and sweeping through them fires off a rapid string of clicks in a row. Each strip was carefully tuned to bend and snap back the same way every time, keeping the click consistent all the way across the row. It's fully print-in-place, so it comes off the build plate fully assembled with zero supports and zero assembly required. A ribbed edge wraps around the outer curve of both lobes for a solid grip, while the circular hub at the center gives it a bold, mechanical look from every angle. At only 7.18 grams and less than 23 minutes to print, this lever fidget is a quick, satisfying build for anyone who loves clicking through a row of clean, repeatable clicks. Boost MeIf you like this model, please consider boosting it! It helps out a ton :)MembershipWant to sell my 3D printed fidget toys? Become part of my Commercial License Membership program!Printing Instructions: Prepare the Print BedClean the print bed thoroughly with isopropyl alcohol to ensure proper adhesion. Additional adhesive for the print bed is highly recommended! I suggest using 3D-Lac spray or a glue stick.   Download the Print ProfileSend the pre-configured print profile to your Bambu Lab printer through the Bambu Handy app or Download and open the pre-configured print profile in Bambu Studio.   Select Your Printing OptionsChoose your filament type and color. Select your print bed type (e.g., textured or smooth). Confirm your printer settings, ideally for a Bambu Lab printer.   Start PrintingBegin the print job. No supports are necessary.