Ergonomic Tool Handle - 20-60mm

Ergonomic tool handle and support ring   Turn any broom, vacuum, or any pole tool into something you can actually use with one hand. This is the latest version of this design with a couple improvements.  Better ergonomic angle + Grip Beter strength - best print orientation for maximum strength Inter-changeable clamps - size 20-60mm width  If holding a long pole with two hands is awkward or impossible, this set gives you a proper grip and a second contact point on the shaft.  The result is more control, less strain, and a tool that feels like it was made for your hand.   Use it on broomsticks vacuum poles garden tools any round pole from 20 mm to 60 mm What to print This set consists of a handle, a support ring and 2 clamps with available sizes from 20 - 60mm width, in combination with M3 heated inserts or M3 nuts. QtyPartProfile1×HandlePrint Profile #11×Support ringPrint Profile #12×Clamps (in your pole size)Profile #2 // #3 (heat-set inserts) or Profile #3 (M3 nuts)            Clamps are available from 20 mm to 60 mm, in 1 mm steps. Choose between the heated insert version or the nut version   Hardware needed 8× M3×12 // M3x16 bolts (machine screws) 8× M3 nuts // M3×3×5 heat-set inserts   Print tip Print the handle exactly as it sits in the 3MF. That orientation gives the best strength, but it does need solid bed adhesion.   Why this exists I lost my left arm in an accident in 2023. Since then I’ve been designing small 3D-printed tools that make everyday jobs a bit more doable, for me, and for anyone else who needs them. This model started out as an early design with lots of flaws. Now its been improved a lot since then and i use this model on a daily basis.     Boost MeIf this helps you or someone you know, a free boost helps me keep making more of these.