Double Sided Halloween Pumpkin Hexagon Fidget

  🎃 Double Pumpkin Hexagon Fidget – Jack O’ Lantern Edition 🎃 It’s pumpkin season, so we gave our double-hexagon fidget a Halloween makeover! This unique two-piece pumpkin fidget snaps together using tabs that align with the grooves (glue for best results), creating a full 3D pumpkin that you can fidget from both sides. A little glue around the outer edge helps keep everything together.   Twist it, twirl it, spin it, pop it, and watch the Jack-O’-Lantern face shift and change as the layers move. Pull it up and it forms a complete pumpkin! The result is a mesmerizing little pumpkin that somehow looks different every time you rotate it.  This prints in about 2 hours. Print this with AMS or no AMS for the plain version changing by layer. See instructions below.   There are two versions: Jack-O’-Lantern – complete with a spooky classic pumpkin face Classic Pumpkin – no face for a simpler fall look Perfect for Halloween, fall, pumpkin season, classroom fidgets, desk toys, sensory toys, and anyone who thinks pumpkins should be fidgeted with instead of carved. No pumpkin guts required.   Print the two halves, align the grooves, add a little glue, and let the pumpkin fidgeting begin!     Instructions Print each side (top and bottom) and remove from the build plate. Align the groove and ridges and then glue on the our edge only. Not much glue is needed. The groove and ridge can hold with proper filament calibration and machine.