Deadpool

Meet the Deadpool Multipart & Multicolor Figure 30 cm If you like this model, be sure to check out my profile. You’ll find many more printable characters, articulated models, multipart figures, and other projects there, with new designs added regularly. This version is designed as a multipart and multicolor model, so you can print the individual parts separately and assemble the complete figure without an AMS. The model includes the main body parts, equipment, swords, and pistol shown in the photos. Assembly Notes Please note that the left and right arm joints have a fairly tight snap fit. When inserting them into the body, you may need to apply a little more pressure than usual. The parts are designed to snap into position, so glue is not required.   The most important thing is to find the correct insertion angle. Try changing the angle slightly while applying steady pressure until the peg enters the body and clicks into place.   I assembled the model shown in the photos successfully, so the connection works. It may simply take a little patience to find the correct angle. If the fit is still too tight on your particular print, lightly sand the inner side of the connecting peg using fine sandpaper, a small file, or a rotary tool. Remove only a small amount of material, test the fit again, and repeat if necessary.   The pistol connection to the hand is also intentionally snug. Align the pistol with the opening in the palm and press it in a little more firmly. Once seated correctly, it should snap into place and remain securely in the hand without glue. Fit can vary slightly depending on printer calibration, filament, flow, and other print settings, so minor adjustment may occasionally be required. I hope you enjoy printing and assembling the model.