Velociraptoe - UG VR

Velociraptoe - Evolved 03   The combined power of 100 (level one) Raptoes!   For this dino, securing the head socket with glue is optional.   Make sure to have good bed adhesion for a successful print (lots of pieces spread across a bed can be difficult for printers.)   Sand down or take care to remove ALL supports on the joints if they don't articulate properly.   Again, just like with the Varugtyl, be careful when removing the supports on the feathers(?), but DON'T worry too hard if some of them break off!   Use PETG or ABS for this model, PLA will cause the joints to loosen in a few days and is reportedly prone to cracking. You're likely going to lose some little feathers and spikes (especially on the tail), unless you have a very tiny printer nozzle. It's okay!