HyperSnap Launcher - High Speed Toy Car Launcher

HyperSnap Launcher Turn your toy-car track into a high-speed launch system with the HyperSnap Launcher. Designed to give toy cars an extra burst of speed, the HyperSnap uses a simple, rubber band powered launching mechanism to send cars racing down the track. ⚡ Fast & Fun Give your cars a powerful launch to see how far and fast they can go. 🎯 Easy to Use Simply place the car into the launcher, pull back the mechanism, and release. No batteries or complicated setup required. Assembly Attach 2 x rubber band to the launcher, one each side. If you are installing the TPU springs 2 are installed into the main body and 1 in each top cover. Use a bit of super glue at one end to secure them. Install the launcher into the main body. Loop the rubber band over the posts at the end of the main body. Install the 2 top covers. Install 4 x screws (6gx30mm long) through the top covers into the main body. Check the trigger pin slots into the main body. (note: this may require slight filing but make sure a firm fit is maintained) Position the trigger on the main body and firmly install the trigger pin. Now you're ready to go!!! Pull back the launcher to lock it in place. Load up a car. Press the trigger to launch!!!!!! 🏁 Great for Racing Perfect for creating your own races, speed challenges and jumps.   Accessories The HyperSnap Launcher Jump & Crash Attachment is the perfect addition to the HyperSnap Launcher.  https://makerworld.com/en/models/3086937-hypersnap-launcher-jump-crash-attachment#profileId-3477525 Printing Please use the print profiles and setting provided in the print profiles for best results. Ensure TPU filament is used for the springs.   Please note: The HyperSnap Launcher is an independently designed product and is not affiliated with, endorsed by, or sponsored by any toy-car manufacturer. Toy cars and track pieces are not included unless otherwise stated.