Sheep - Sculpt Clicker

After a little break, we’re starting again with something sweet. Meet the Sheep Sculpt Clicker! 🤍   For this model, I set the recommended layer height to 0.12 mm to help hide the layer lines and seams as much as possible.   Especially with sculpted designs where the head is slightly tilted, layer lines can become much more noticeable on the curved surfaces. If you want an even smoother result, you can always increase the print detail further by using a lower layer height.   🔑 Keychain bottom included if you'd like to carry your favorite one with you.   ⚠️ MX-style 14x14 mm mechanical keyboard switch required (Cherry MX, Gateron, Outemu, Akko, Kailh, etc.). The switch is a press-fit and should snap into place without glue.   Hope you enjoy this little sheep! 🐑✨