Dominator 3 | 1:32 scale | Suspension & deployable

Reed Timmer's Dominator 3 Tornado Interceptor Model Features: Functional suspension that allows the vehicle to lower toward the ground, just like the real Dominator 3. Two ground spikes positioned in the same locations as the real vehicle. 1:32 scale Required Tools: Before assembling the model, make sure you have: Drill and drill bit (the bit should match the diameter of your 3D printer filament) Heat source (a hot glue gun is recommended) A tool capable of making clean, accurate cuts to filament (flush cutters or side cutters work well) Assembly Instructions: Note: Work slowly when drilling and bending the suspension pieces to avoid cracking the printed parts. 1) Carefully remove the bottom of the dominator 3 from the print bed. 2) Gently bend the suspension flaps outward. Drill each suspension hole so it matches the diameter of your filament. 3) Drill the centre hole of each wheel to the same diameter as your filament. 4) Cut a piece of 3D printer filament to use as the axle. Feed it through one wheel, the suspension hole, and then the opposite wheel. 5) Melt each end of the filament axle using a hot glue gun (or another suitable heat source) to create a small mushroomed end. This keeps the wheels securely in place and prevents the axle from sliding out.