Textured Minecraft Chest

I had this idea for a textured Minecraft chest that looked almost real. I used HueForge to make the panels, which print flat and are inserted into the print, mid-print. This means you don't need an AMS or Glue to put it together and it uses almost no waste.   Instructions Print the panels first. Print the chest bottom or top, and insert the panels into the slots when it pauses and resuming after each one.The first pause will be for the bottom panel, which is placed textured side down on the build plate. The second pause is for the side panels, which only go in one way and will be flush with the rest of the top when properly placed. Assemble the two halves by inserting the hinges and pins. Add the latch by sliding it through the hole and clipping it in place. Insert magnets or the card insert if you want. Enjoy! There's a profile for the AMS and one for non AMS. The AMS profile just has the color swaps setup at the correct heights. The No AMS profile just has pauses to change the filament. When printing the panels, start with black. At the first pause, change the filament to a Brown. At the second pause, change the filament to an Orange. Filament Selection The specific colors I used are Bambu Basic Black, Bambu Pumpkin Orange, Bambu Cocoa Brown all in PLA. I'm sure most black's, browns, and oranges should work well but I can't be sure since I used HueForge to make this and every filament has a different transmission distance and might look differently.   I might add on a version where the panels are just glued in instead of inserted mid-print.   The card holder is a separate print that just clips into the inside of the chest securely. Important Notes! Make sure the inserted panels do NOT sit above the current layer! The hot end could collide with the part if it is misaligned. If this happens it WILL cause issues (hot end breaking, bending, clogging, etc.…), you have been given fair warning :D   If the part starts lifting off the bed, i.e. corners warping, then the panels won't sit right and you will either have to shave off some plastic with a knife so the panel can sit flush, or re-print it. If you have trouble with it lifting off the bed, you may have to use some adhesive or a brim. IncorrectCorrect      Disclaimer: NOT AN OFFICIAL MINECRAFT PRODUCT. NOT APPROVED BY OR ASSOCIATED WITH MOJANG OR MICROSOFT.