The Pepper – Stronghold Bug-A-Salt Wall Mount

Stronghold for your fly blaster The Pepper gives your Bug-A-Salt a dedicated place on the wall: cleanly stored, easy to grab, and ready when a fly shows up uninvited. Instead of leaving it on a counter, shelf, or somewhere nobody remembers, it becomes part of your ready-to-grab home or shop loadout. Key features / configuration Compact wall mount designed for a Bug-A-Salt fly killer. Clips onto the upper section of the Bug-A-Salt for quick attachment and release. Designed around the shared upper-body mounting area found across Bug-A-Salt versions; test-fit with your specific version before permanent installation. Small, efficient print that can be completed in under 40 minutes. Two mounting holes support a secure screw installation, ideally into a stud or solid wood backing. Flat rear mounting surface can also be used with quality double-sided tape or a 3M-style semi-permanent wall-mount solution. Keeps your Bug-A-Salt accessible in a garage, workshop, utility room, mudroom, kitchen-adjacent space, or near a patio door. Compact footprint of roughly 50 mm tall by 40 mm wide. Design and vibe The Pepper is a compact Stronghold component built around one job: giving your fly blaster a dependable home base. The low-profile clip keeps it off counters and benches without putting it out of reach. It is intentionally practical rather than decorative. The direct quick-release hold and small wall footprint make it the kind of organizer that quietly does its job until you realize you always know exactly where the Bug-A-Salt is. Stronghold Collection The Pepper is part of the Stronghold collection: rugged, mission-ready organizers designed around specific “domains” in your life and workspace. Stronghold pieces are meant to feel like gear—purpose-built, clearly labeled, and tuned for one job. The Pepper is the Stronghold for your fly-defense setup, turning countertop clutter into a focused, ready-to-grab loadout. Support the maker Boost MeEvery Boost, like, comment, and make share helps fuel more Stronghold/Hearthmade designs. If The Pepper earns a spot on your wall, consider uploading a make or leaving a quick note about how you used it—think of it as the 3D-printing version of “buying a cup of coffee,” and it genuinely helps decide what to design next.  If The Pepper earns a place on your wall, share a photo of the space where it is on duty. A Boost is the 3D-printing version of buying a cup of coffee—it helps cover filament, testing, and the next practical design.