Pokémon Solgaleo 14.5cm Multipart | No AMS

IMPORTANT ASSEMBLY NOTE This is a multipart display model. Please dry-fit every connection before applying glue. Minor sanding may be needed depending on your printer calibration. The mane spikes, tail tip, facial details, and flame effects are thin parts, so remove supports slowly and handle them carefully. If you find a fit issue, please leave a comment with the affected part and I will review it. Your likes, boosts, collections, and make photos are the best encouragement for future models. Thank you for supporting the project! Solgaleo is presented here as a detailed multicolor FDM display model. The design preserves the iconic white armor-like body, blue facial mask, gold solar rays, red markings, black torso section, cyan details, and orange flame effects. MODEL INFORMATION Assembled size: 124.08 × 172.42 × 145.00 mm Finished height: approximately 14.5 cm Mesh components in the assembled reference: 71 Project plates: 9 Recommended materials: PLA for the main model; the orange effect plate is configured as PETG and may also be printed in orange PLA if preferred No AMS required: color groups are separated onto individual plates IMPORTANT PLATE NOTE Plate 1 is the complete assembled reference used for size and appearance verification. Do not print Plate 1 as an overlapping assembly. Print the separated color-part plates that follow it. VERIFIED PROJECT SETTINGS Printer profile: Bambu Lab A1, 0.4 mm nozzle Layer height: 0.16 mm Wall loops: 2 Sparse infill: 15% Supports: enabled, tree (auto) Brim: automatic, 5 mm Print sequence: by layer PRINTING AND ASSEMBLY TIPS 1. Keep the original orientations and plate layout in the supplied 3MF, especially for the mane rays, tail tip, and flame-effect parts. 2. Print Plates 2–9 by color. Plate 1 is an assembled reference only. 3. Retain the automatic brim for tall or narrow flame-effect pieces. Let the build plate cool before removal. 4. Remove tree supports from the mane, facial details, paws, and flame branches in small sections rather than pulling them off at once. 5. Dry-fit the four legs and torso first so all paws sit flat. Then install the head and mane sections, followed by the tail and flame effects. 6. Check the orientation of the left/right mane rays and the tail tip before gluing. Several pieces are visually similar but are not interchangeable. 7. Use only a small amount of adhesive after the parts are fully seated. If a joint is tight, lightly sand the contact surface instead of forcing a thin part. This model is intended for personal display and fan creation. Enjoy the print, and please share your finished make!