Naruto Hueforge

Project: Naruto2.hfp Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 156x234mm in size You may print at higher layer heights below the Base Thickness of 0.48mm The Max allowed Thickness is 2.56mm and the Actual Thickness is 2.48mm     #000000 PLA BambuLab Basic Black  Transmission Distance: 0.1     #c00d1e PLA BambuLab Basic Red  Transmission Distance: 3.7     #fce300 PLA BambuLab Basic Yellow  Transmission Distance: 5.2     #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5.8     #0086d6 PLA BambuLab Basic Cyan  Transmission Distance: 2.4 This print uses 5 unique filaments Swap Instructions:     Start with Black     At layer #6 (0.56mm) swap to Red     At layer #10 (0.88mm) swap to Yellow     At layer #11 (0.96mm) swap to Jade White     At layer #14 (1.2mm) swap to Red     At layer #15 (1.28mm) swap to Yellow     At layer #19 (1.6mm) swap to Black     At layer #20 (1.68mm) swap to Jade White     At layer #28 (2.32mm) swap to Cyan for the rest.   For single AMS users, start with 4 colors as follows, Slot1: Black Slot2: Red Slot3: Yellow Slot4: White Pause was set at Layer 21 to allow color swap: Slot2: Red --> Cyan