Varugtyl - UG VR

"…Regardless, the Varugtyl is an extremely social dinosaur(?) who forms a strong bond between the UGly who hatches it.” -Dinodex, Official UG VR Discord.   Varugtyl - Climber 01 According to multiple reports, the Varugtyl likes to spend most of its time in Ugtopia's dark caverns.   Sand down or make sure to thoroughly remove ALL supports on the arm and foot joints if they get stuck or fall off.   *Disclaimer; your Varugtyl won't actually stick to walls by itself.   Be careful when removing the supports on the feathers(?), but DON'T worry too hard if some of them break off. I lost quite a few while assembling, and it still looks great.  Again, you're likely going to lose some little feathers and spikes (especially on the tail), unless you have a very tiny printer nozzle. It's okay!   You're definitely going to need clippers or a small poking tool to remove or clean up supports.   Make sure to have good bed adhesion for a successful print (lots of pieces spread across a bed can be difficult for printers.) Use PETG or ABS for this model, PLA will cause the joints to quickly become floppy.