Rebel Riviera M1 - Cyberbrick Vintage RC Speedboat

A sleek, classic-inspired micro speedboat engineered specifically for the stock Cyberbrick ecosystem. Powered by a twin-motor differential thrust setup—no servos, rudders, or complex linkages required.   ----------------------------------------------------------   🚤 Key Features Single-Kit Build: Uses only a single Cyberbrick Beginner Hardware Kit Differential Steering: Simple rotational control using dual counter-rotating 3-blade propellers. Easy to print and assemble: Carefully tuned, thoroughly tested print profiles. ---------------------------------------------------------- 🛒 Support This Project (At Zero Cost To You!) If you're purchasing the required CyberBrick hardware or filament anyway, consider ordering through the Bill of Materials on this page. It doesn't cost you anything extra, and the small commission helps fund future projects. Thank you!   ---------------------------------------------------------- 💦 The Nerd Zone (Engineering Highlights) Double-S Labyrinth Deck Seal: Interlocking double-rib and groove joints route along the hull perimeter. The tight S-curve geometry blocks wave spray and nose dips without needing soft gaskets. pushing a thin bead of grease (also included in the Cyberbrick KIT) in the groove creates an airtight, hydrophobic barrier. Grease-Chamber Shaft Logs: The propeller shaft tubes feature an integrated internal grease cavity. Packing this chamber with grease creates a low-friction liquid barrier that stops water from creeping along the propeller shafts into the hull. ---------------------------------------------------------- 🪢 Water Safety & Disclaimer Note: This model is engineered to be safely playable and highly splash-resistant for normal surface driving. However, stock Cyberbrick electronics are not waterproof, and this hull does not hold an official IP rating. Avoid intentional submersion or diving. The author is not responsible for any electronic hardware damage resulting from water ingress, capsize, or improper assembly. ---------------------------------------------------------- ❓ Frequently Asked Questions (FAQ) Q: Which version of the CyberBrick Official Standard Remote should I print? A: I strongly recommend printing the Lithium Battery Version for the best stability and performance: If you by any chance already own the Cyberbrick Ultimate Hardware Kit ZK003: You already have an extra Li-ion battery included for the Remote! If you are buying hardware now: A Li-ion Battery is listed in the BOM widget, this is optional. Keep it checked in for the best remote performance, or uncheck it to save ~ €4.59 if you plan to build the standard AAA remote.  If you decide to not buy the optional Li-ion battery and build the AAA remote version: If you experience unexpected remote shut-offs, simply plug a USB-C phone charger or power bank directly into the remote board while driving for a stable power supply. ------------------------------------------------------------------------------ 🧼 Clean The Buildplate Before print, clean the buildplate thoroughly by hot water and liquid soap (NOT IPA!!!) This is crucial to prevent possible print failures. Boost Me📸 Show Off Your Build! If you print one, I'd love to see it in the Makes section. Seeing your finished builds is one of the best parts of sharing these projects. 😊---------------------------------------------------------- 🏎️ Want to try a fast RC car? If you enjoyed this boat, check out my flagship project, the Rebel 787-C1, the fastest, best handling Cyberbrick car available. Designed over 4 months, it is a high-performance, 4-motor monocoque RC racer packed with custom engineering innovations. 16+ km/h Quad-Motor Micro Prototype Racer Functional Rear Differential & pan car style suspension Prints in a single buildplate in 7 hours, 30 minute assembly. you can do it 😉 👉 Check out the Rebel 787-C1 Model Here