Bambu Lab Spool Filament Clip - AMS and AMS 2 Pro

🧵 Bambu Lab Spool Filament Clip - Snap-On Version I was always looking for the perfect spool filament clip, but most designs I tried had issues: they interfered with the AMS, came off, broke, were hard to align, or eventually became loose.   So I designed my own.   This clip is made specifically for Bambu Lab spools only and is tuned for a secure, reliable fit.    Unlike the original version, where the filament is inserted through the clip, this new design lets you simply press the filament into the clip from the side.   Compatible with AMS and AMS 2 Pro  Does not interfere with spool movement Allows the spool to roll freely Uses 5 alignment points to lock securely in placeIt won't come off after use or after drying cycles Tight tolerances tuned for PETG/ABS/ASA/PC Designed to be durable and long-lasting Prints in under 5 minutes Uses less than 0.6 g of filament Small, quick, and practical — print a few and keep them around.   ⚙️ Installation ⚠️‼️  Please follow these instructions carefully. The top pins (x2) may look fully inserted when they are not. Use firm pressure to make sure they match the picture. Pro tip: Lightly press them with pliers to ensure they go fully in and do not come loose. You should hear a satisfying snap when they fit into place. ⚠️‼️  Watch installation video below:    🖨️ Printing Notes Recommended material: PETG (or ABS/ASA/PC if your spools support it) No supports required.   FOR ORIGINAL BAMBU LAB SPOOL Snap-On Version (THIS MODEL) FOR THE REPLICA OF THE BAMBU LAB SPOOL FOR ORIGINAL BAMBU LAB SPOOL (original Insert Version)